How to Assemble the ProDesign Washer and Squeegee
The tools in the ProDesign kit come disassembled. To assemble the window scrubber press the spring release on the handle and slide the wash bar into place.
Next unsnap the closure on the wash sleeve and insert the wash bar into the end, through the elastic and re-snap. The wash sleeve is designed to be easily removed to launder or replace.
To change over to the squeegee press the spring release on the handle and remove wash bar. Then slide the squeegee channel with rubber into the handle as shown in the photo. To use with a regular threaded extension pole use the included taper adaptor.
Instructions for Washing Windows with the ProDesign Washer and Squeegee
Mix 1/2 ounce of premium dish washing liquid per 1 gallon of distilled water in a bucket. Distilled water is preferred to hard water because it does not contain minerals which can leave behind streaky residue on your windows after cleaning. Avoid ammoniated cleaners as they reduce the life of your squeegee’s rubber blade. Dip a Mr.LongArm window scrubber into your solution, squeeze out the excess solution and scrub the entire window. Work from the outer edges of windows toward the center, scrubbing in large circular motions.
Next switch to your squeegee blade and squeegee the solution from the glass, starting at the top. Angle blade downward, apply light pressure and squeegee window with complete strokes. Dirt and water will be lifted off your windows leaving them cleaner and shinier. Move horizontally and overlap each stroke by 1-1/2 inches. Wipe the squeegee blade between each stroke with a clean, dry and lint-free microfiber cleaning cloth.
Squeegee entire window and wipe edges with a dry clean cloth. It is recommended that you clean upper windows first and then clean your lower windows.
If you have additional questions about using our ProDesign Washers and Squeegees you can contact Mr. LongArm’s Customer Service Department at 816-537-6777 or 1-800-821-3508. You can also use our Customer Contact form.